STUDIES ON THE INFLUENCE OF TESTING PARAMETERS ON DYNAMIC AND TRANSIENT PROPERTIES OF COMPOSITE SOLID ROCKET PROPELLANTS USING A DYNAMIC MECHANICAL ANALYZER doi: 10.5028/jatm.2012.04044012

Authors

  • Vilas Wani High Energy Materials Research Laboratory Pune
  • Mehilal Mehilal High Energy Materials Research Laboratory Pune
  • Sunil Jain High Energy Materials Research Laboratory Pune
  • Praveen Prakash Singh High Energy Materials Research Laboratory Pune
  • Bikash Bhattacharya High Energy Materials Research Laboratory Pune

Keywords:

Glass transition temperature, Storage modulus, Loss modulus, Polybutadiene, Viscoelastic properties

Abstract

Dynamic mechanical analysis is a unique technique that measures the modulus and damping of materials as they are deformed under periodic stress. Propellants, which are viscoelastic in nature, are subjected to time, temperature, and frequency effects during the analysis to determine their dynamic and transient properties. The choice of parameters during the experiments like temperature, frequency, strain (%), and stress level is very crucial to the results obtained since the propellant behaves differently under different conditions. A series of experiments like strain and temperature ramp/frequency sweeps, creep, stress relaxation, etc. have been conducted using high burning rate composite propellant (burn rate ~20 mm/s at 7,000 kPa), in order to determine the precise effects of such parameters on the results obtained. The evaluated data revealed that as the temperature increases the storage modulus, loss modulus, and tan delta curves with respect to the frequency shift towards the lower side. Moreover, there is equivalency between the increase in the temperature and the decrease in the frequency, which can be used for the time-temperature superposition principles. Further, in transient tests, the relaxation modulus has been found to decrease when increasing strain levels in the given time range. Also, relaxation modulus versus time curves were found to shift towards the lower side with increasing temperature while creep compliance decreases with the increase in stress and decrease in temperature. The glass transition value of the composite propellant increases when there is an increase in the heating rate.

Author Biographies

Vilas Wani, High Energy Materials Research Laboratory Pune

Mehilal Mehilal, High Energy Materials Research Laboratory Pune

Sunil Jain, High Energy Materials Research Laboratory Pune

Praveen Prakash Singh, High Energy Materials Research Laboratory Pune

Bikash Bhattacharya, High Energy Materials Research Laboratory Pune

Downloads

Published

2012-12-13

Issue

Section

Original Papers